Compensator for PX4

Compensator for Marui's gas handgun, BERETTA PX4.

■Product Overview
A rare custom part for the PX4.
The design is based on a compensator that exists for real firearms, with the addition of a rail.
Confirmed to fit Marui's PX4 and compatible models.
The design follows the subtle angle of the slide.

■Installation Method
Lightly tighten the pre-installed set screw with a 1.5mm hex wrench to secure it.
A separate stopper part is included to prevent damage to the firearm.
If the part is difficult to remove even when the screw is loosened, try sliding it back and forth gently, or lightly tap it on a surface like rubber to lower the stopper.

■Precautions
The firearm is not included in the sale.
This is a personally produced item made with a 3D printer, so layer lines and some roughness may be visible.
While there have been no complaints about previous sales, please do not have excessive expectations.
We use a material called carbon fiber PLA, which is stronger and heavier than ABS and has a low gloss finish. However, please be aware that extreme force or temperatures above 60°C may cause breakage or deformation.

#Click here for other original custom parts

Resale at inflated prices and unauthorized reproduction of images are prohibited.
Please be cautious of inflated prices on platforms like Amazon.