Marui Hi-Capa 4.3 Compensator

This is a compensator compatible with the Marui Hi-Capa 4.3 series.
It has a very tactical design.

The rail slots on the bottom enhance its imposing appearance and versatility for accessory attachment.
It also functions as a strike face, allowing the hammer to drop even when the muzzle is pressed against a surface.

To install, slide it onto the Hi-Capa's rail from the front and tighten the bottom grub screw with a 1.5mm hex wrench.
(Be careful not to overtighten.)
This new version has been designed with separate parts to prevent damage to the main body.

Compatibility with barrels with silencer threads has not been confirmed, but if the part extending from the slide is narrowed by threading, it may attach by removing the thread cover.
(Slight marks may remain on the bottom of the frame.)

■Important Notes
The compensator and grub screw (pre-installed) are the items for sale.
Please note that the gun, custom magazine bumpers, and other items are not included.
When installing, always leave a gap of about 0.4mm to ensure the slide does not hit the compensator.
The design is subject to change for improvement.
This is a personally made product using a 3D printer. There may be some roughness or minor scratches as shown in the photos. Those who are sensitive to such details or concerned about the condition should refrain from purchasing.

The material is carbon fiber PLA.
While it has a certain degree of strength, it differs from mass-produced products and is weak to heat above 60°C. Please be especially careful in hot environments such as inside a car under the summer sun.
A 2-week warranty against breakage is included.
Please inquire about discounts for bulk purchases.

#Other Original Custom Parts Here

Purchase for resale and unauthorized use of images are strictly prohibited.